What Fittings Are Needed For Copper Pipes?

May 26, 2022 4:04 pm

Categories:

When installing copper pipes, you will need to buy a variety of different copper pipe fittings. Copper fittings typically have two main types: soldered and non-soldered. Soldered fittings are more expensive than non-soldered, but they are still the preferred method. Non-soldered fittings can be used in some situations, such as replacing damaged pipes. Copper pipes that have bulges are impossible to fit into new fittings, but double female connectors can be used to repair bulged pipes.

Image credit

Another type of fitting is the compression type, which bites into the pipe and a brass ring seals around it. This type of fitting is the oldest solderless connection. When an installer tightens the nut, a brass ring wedges against the pipe. This connection method is more secure but does not provide structural strength. Consequently, compression fittings need more hangers than other fitting types.

Compression fittings are the most common type of fitting. These fittings are designed to secure copper pipes by squeezing the ferrule against the pipe. Compression fittings are made with a compression nut and a compression ring. They should be tightened until they are hand-tight. Pipe joint compound can also be used to lubricate the copper pipe. Thread-sealing tape is a common type of pipe joint compound. When you need Copper Pipe Fittings, go to a site like watkinspowis.co.uk/products/copper-pipe-fittings-and-press-systems/

Image credit

Before soldering copper pipes, make sure that the copper pipes have been cleaned thoroughly. Use a high-quality sandpaper to sand the pipe up to 1/2 inch beyond the fitting. A fitting brush is also helpful for priming the inside of copper fittings. Always wear safety gear when soldering pipes. You may need a fire cloth, a fire extinguisher, or a fire-safe spray bottle.

Among the many types of fittings available, couplings are used to connect two pieces of copper pipes. These fittings are available with reducer options for connecting different-diameter pipes. Union fittings also connect two pieces of copper pipes. They offer quick connection and disconnect. Caps are also used to cover the ends of copper pipes. Tee fittings are used to split the pipe into two pieces.

Copper fittings are made of copper that is much thicker than copper pipes. A solder joint is not visible until it reaches the melting point. When the pipe and fitting are at the melting point, the solder will melt and draw the joint together. Keeping a careful eye on the pipe is important to ensure a solid and tight joint. Before you solder them, use a special clamping tool and be sure to check that the parts fit properly. A solder connection is both gas and liquid tight, making it a good choice for connecting copper pipes.